[W126 Coupe] Temperature sensor in receiver drier

[Dan Gardner]

HI Folks

    I am in the process of rebuilding my Nippondenso 10P 17C had some delay 
waiting for parts, Century Air in Arizona were very helpful.After fitting 
the clutch I got the air gap to .003 but there is a slight circumferential 
variation .As the rear cluth plate is held with the circlip I can't seem to 
see what part moves together when the coil is energised.

    The other problem is that the new receiver drier which I got from 
Germany has a larger thread where the temperature sensor fits its the same 
size as the switch which fits OK.
 I am thinking that this sensor may have come with the second replacement 
R/D which was a GIN CHERN from China or Taiwan.All advise gratefully 
received.


                                                                             
                                    Kind Regards Dan Gardner 1986 560SEC 
Euro