[W126 Coupe] M117 + trans length

[Josh Allen]

I should be able to measure a 117 engine alone to give the engine lengths. 
I will likely be going over to the garage where the engine is stored 
today, so I will try to get that for you, if someone else doesn't 
already have it!

-Josh

Mike R. wrote:

>> From the front face of the bell housing flange to the rear of the 

> three-prong output adapter for the flex disk is 25 7/8". Don't have my 

> engine anymore so someone else will have to provide that number.

>

> Later,

> Mike R

> ----- Original Message ----- From: "Mike Kelly" <ramcram at bigpond.net.au>

> To: <mbcoupes at mbcoupes.com>

> Sent: Sunday, December 14, 2008 4:30 PM

> Subject: [W126 Coupe] M117 + trans length

>

>

>> Hi Guys,

>> Can someone tell me the length of the motor and trans for my '89SEC?

>> My hoist is currently out of action and I need the length from the 

>> front of

>> the harmonic balancer to the rear of the trans output flange where the

>> rubber donut bolts.

>> Mike Adelaide South Australia

>> '86 560SEL

>> '89 560SEC