[W126 Coupe] M117 + trans length - FrankenBenz

[Mike R.]

VERY &*$%^& slowly. I just hate it when work gets in the way of play!! I 
need a couple of hours to finish figuring out the motor mounts, then I'll 
whittle them out of some steel and get them welded in. I'll have the pieces 
I've cut to close up the GTO front sump welded in. Then it's put the sump on 
the LS6, bolt the tranny to the motor, and drop it into the SEC so I can 
start on tranny mounts. I was trying to get the engine/tranny in the car by 
Christmas but work has completely dinged that idea. At least I can afford 
parts. :-)

Later,
Mike

----- Original Message ----- 
From: "Steve Nervig" <dakota at mac.com>
To: "Mercedes Coupes Mailing Lists" <mbcoupes at mbcoupes.com>
Sent: Sunday, December 14, 2008 5:09 PM
Subject: Re: [W126 Coupe] M117 + trans length



>

> On Dec 14, 2008, at 4:45 PM, Mike R. wrote:

>

>>> From the front face of the bell housing flange to the rear of the

>> three-prong output adapter for the flex disk is 25 7/8". Don't have  my 

>> engine anymore so someone else will have to provide that number.

>>

>> Later,

>> Mike R

>

> Hey, Mike. How's the Frankenstein coming!

>

> Regards,

> Steve

>

>

> --

> "I don't mind a reasonable amount of trouble."

>

> The MB Coupes Website!

> W126 SEC Mailing List

> Postings remain property of MB Coupes, L.L.C.