[W126 Coupe] distributer cap

[GreyGarageRuss at aol.com]

Thanks Gary.  I tried those “screw out” tools...wouldn’t screw them  
out...wouldn’t budge them.  Thanks anyway.
Russell
1988 560  SEC
Gary <_garysalas at yahoo.com_ (mailto:garysalas at yahoo.com)   wrote: 
go to sears and get the screw out tools about 20 bucks
 
_GreyGarageRuss at aol.com_ (mailto:GreyGarageRuss at aol.com)  wrote:  Thanks to 
Jonathan.Satish and others who responded to my query (below) on spark  plugs 
for my SEC. I finally found the time to try to install the W9DCO plugs  along 
with new wires, cap and rotor. I have the new plugs and wires in but my  old 
distributer cap won't come off two of the three screws are damaged and won't  
turn. I have been told that I should grind these screw heads off, remove the cap  
and use a torch to heat the area around the screws to try to loosen them!! My 
 question is: Is there any other method to remove these screws and if not, 
will  the torch cause any other damage?? Thanks,  Russell




   
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.pairlist.net/pipermail/mbcoupes/attachments/20071108/7561da27/attachment.htm>