[W126 Coupe] Hydraulic suspension

[Iain Gunn]

Thanks Again, Enjoy the Easter Sunday, Iain
  ----- Original Message ----- 
  From: Jonathan Hodgman 
  To: Mercedes Coupes Mailing Lists 
  Sent: Sunday, April 08, 2007 4:50 PM
  Subject: Re: [W126 Coupe] Hydraulic suspension


  No, it's easy..  the two lines and 4 5mm bolts.  If you pull a bolt from the pump and it's short, put it back in as that's one of the ones that holds the two halves of the pump together.

  Jonathan


  On 4/8/07, Iain Gunn <igunn at bmts.com> wrote:
    Thanks for the help, One more question.The manual doesn't give much info as there are several pumps they show. Is this a big deal to pull??        Thanks again, Iain
      ----- Original Message ----- 
      From: Jonathan Hodgman 
      To: Mercedes Coupes Mailing Lists 
      Sent: Sunday, April 08, 2007 3:17 PM
      Subject: Re: [W126 Coupe] Hydraulic suspension


      You would want to pull the pump as a whole and put a block off plate on there.  Doesn't have to be anything fancy if it's short term.  Just need to seal around it to prevent any oil from leaking.

      Jonathan






      On 4/8/07, Iain Gunn <igunn at bmts.com> wrote: 
        Can I just remove the inside of the pump, or the complete pump?. Do I have to make a cover to close it off?
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.pairlist.net/pipermail/mbcoupes/attachments/20070408/0390279f/attachment.htm>