[W126 Coupe] Looking for AMG spoilers

[Dick Spellman]

Hi Attila:

They will fit the 87 560SL chassis R107.  They are deep enough for the 
US crash bumpers and have cut-outs for the rubber bumper attachments 
that will remain visible.  These are fiberglass pieces not the original 
AMG urethane pieces.  They sit right in place over the front and rear 
bumpers and will require you pop rivet them in place from the lower 
(non-visible) side of each bumper.  They fit very snug but, I'd still 
secure them with aluminum stud pop-rivets.  The side skirts fit just 
under the fender urethane covers and are again pop riveted under the 
side panel urethane trim covers and again into the rockers from underneath.

I can pull together a photo or two if you can wait while I run through 
the photo folders tomorrow.  I recall laying them out on the pavement 
and slipping them in place.  Not sure which photos I took but, I'll check.

Dick

attila13 at bellsouth.net wrote:

>           Do you see any issues using them on an '87 560SL?
>           Or, will they just bolt right-up?
>  
>