[W126 Coupe] AC Problem Part 3

[Tom Oelsner]

Hi Dick,
The 90 560SEC does not have a glove box because of the second airbag.
What's the best way to check if it is the vents are fully closed if I can't
get to it via the glove box?

Coolant temp was in the same range.

There was considerable squeal after the first 600 or so miles, minor squeal
the next time; no squeal now. just more loose than when I tightened it the
last time..between .5" and .75" of deflection in either direction.
Tom
  -----Original Message-----
  From: mbcoupes-bounces at mbcoupes.com
[mailto:mbcoupes-bounces at mbcoupes.com]On Behalf Of Dick Spellman
  Sent: Tuesday, October 11, 2005 5:28 PM
  To: Mercedes Coupes Mailing Lists
  Subject: Re: [W126 Coupe] AC Problem Part 3


  Hi Tom:

  So you were able to get good AC performance on a 70 degree day and at all
speeds and the blower and upper vents are confirmed as working properly.
Have you confirmed that the air make-up door (fresh air/recirc door) just
above the blower motor and behind the passenger dash glove box is working
properly?  That is with AC on the door is open only 20% or with the AC set
to MAX the door is filly closed.  Closed being up against the engine
firewall not down against the cabin wall.  Pull the glove box and observe
it's operation to confirm it's working.  If you have access to a MightyVac
(MV), pull the vac lead along side the ACC controls (look for the nicely
colored vacuum distribution manifold) attach the MV and pump it up to see if
it holds a vacuum.

  The only other possibility would be the performance of the refrigerant
when the outside air is hot and the 'engine coolant' is running hotter than
it was today your 70 degree day.  Which begs the question was the coolant
temp in the same range as you reported when it was 95 degrees?  I am going
to bet it was fine which means all of your work was fine up till this
failure.

  When you go to adjust the belt tension on the Nippo compressor what are
you adjusting?  Just pulling up on the idler pulley, right?  And then you
snug the pulley hold down bolt which is a 17 or 19mm and when you check this
later it's still torqued and the belt seems properly tensioned when first
done?  Just how slack does it get?  Do you hear the belt squealing when the
ac clutch engages?  Does the squeal go away?  No squeal at all and the belt
is therefore suffiently tensioned to do the job.

  Tom, I think the first step is to check and see if the vacuum elements
(there are two) on the fresh air/recirc door have failed to cause your most
recent problems.  If one is gone, replace both element rubber diaphrams.
George Murphy sells the kits, they work just fine.  If you find this to be
the problem, call me and I'll provide the email and phone info.  Not handy
just now.

  Dick
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.pairlist.net/pipermail/mbcoupes/attachments/20051011/d552fd56/attachment.htm