[W126 Coupe] AC Blower not working

[Dick Spellman]

Hi Paul:

I think the R&R process is in the cd manual but from memory on the 126
blower you need to:

Remove both passenger carpeted side panels in the foot well
followed by the knee bolster to expose the blower cover.

Remove the 1/2 dozen screws and pop the cover off being careful not to
damage the small diameter rubber seal that sits in the blower housing
groove.

>From there it's a matter of unplugging the speed regulator wire harness and
freeing up the screws/bolts holding the blower motor and squirrel cage in
place.

Do you have the manual or do you need the PDF sent your way?  Others will
need to fill you in on the bearing and brush check as I have simply replaced
not knowing I could have affected a repair.

I think if you are tall the effort is easier with the seat removed where you
are upside down and it's tough to navigate with your body out the door.

Regards,

Dick