[LargeFormat] Pins for Reducing Back

[Les Newcomer]

I've just used the proper diameter nail, drill the hole slightly 
smaller (so it won't split) and drove it in.  then I took a dremel tool 
and rounded/polished the head so it looked like a pin and didn't slice 
my finger open.  I suppose you could use a needle bearing roller, it 
would be polished and hardened.

Les
On Sunday, July 27, 2003, at 01:07  PM, Benno Jones wrote:

> I found a 4x5 back for my B&J 5x7 flatbed but it only has the pins 
> that fit
> into the metal fittings on one side.  Any idea where I can find these 
> little
> guys or what would make a good substitute?
>
> Thanks,
> Benno Jones
>
>
> _______________________________________________
> LargeFormat mailing list
> LargeFormat@f32.net
> http://www.pairlist.net/mailman/listinfo/largeformat
>