[flow-tools] No reports filtering interface indexes

[Mark Fullmer]

Are you sure there is traffic on the output interfaces listed?

Try running the data through flow-stat -f18 (output interface) or
-f22 (input/output interface) and see what shows up.  The equivalent
flow-report formats are 'output-interface' and 'input/output-interface.'

mark

permit 98,99,100
On Thu, Nov 28, 2002 at 03:04:47PM +0100, Christian Cinetto wrote:
> Hi, I tried to generate some reports filtering only the input or output 
> interface index.
>  I attempted it many times using flow-tools-0.59 and  I tried again to do 
> that through flow-tools-0.62.
>  All my effotrs lead me into an empty report!
> 
> This is as I did:
> 
> myfilter
> 
> filter-primitive Infn
> type ifindex
> permit 98,99,100
> 
> filter-definition ente
> match output-interface Infn
> 
> 
> then :
> >flow-cat ft-v* |flow-nfilter -f DIR/myfilter -Fente |flow-stat -f8  
> 
> #  --- ---- ---- Report Information --- --- ---
> #
> # Fields:    Total
> # Symbols:   Disabled
> # Sorting:   None
> # Name:      Destination IP
> #
> # Args:      flow-stat -f8 
> #
> #
> # IPaddr         flows                 octets                packets
> #
> >
> Could someone help me to get out of this , please?
> 
> Thank you in advance.
> 			Christian Cinetto
> 
> 
> 
> 
>  
> 
> -- 
> *******************************************
> *	      Christian Cinetto           *
> *    		                          *
> *	   Network Operation Center       *
> *           	  G A R R	          * 
> * 	  christian.cinetto@garr.it       *
> *                                         *
> *              Fax 06/43361444            *
> *	       tel.06/43361474            * 
> *******************************************
> 
> 
> 
> 
> 
> _______________________________________________
> flow-tools@splintered.net
> http://www.splintered.net/sw/flow-tools