[W126 Coupe] ABS brakes

[Jay Hirsch]

Dick and Markus
Thank you
Jay
On May 11, 2010, at 11:06 AM, Dick Spellman wrote:


> On 5/11/2010 11:01 AM, Jay Hirsch wrote:

>> In  changing  brake fluid and then bleeding system for air  

>> bubbles, what

>> is the correct procedure, steps to follow?

>>

>> With non-ABS bleeding procedure is simple...do wheel furthest from

>> master and then next wheel etc.

>>

>> With ABS do you bleed the ABS control module first, and then do the

>> wheels or do the wheels and then the ABS control?

>>

>> thank you

>>

>> Jay H

>> The MB Coupes Website!

>> W126 SEC Mailing List

>> Postings remain property of MB Coupes, L.L.C.

>>

> Jay,

>

> Replace the two rubber sensor caps (MB Dealer) on the brake fluid  

> reservoir.  Purchase a Brake Bleeder.  Pump to 26-28 lbs once  

> attached to the reservoir.   Bleed pass rear, driver rear, pass  

> front, driver front.  Bleed each until fluid runs clear.

>

> That's it.

>

> -\Dick

> The MB Coupes Website!

> W126 SEC Mailing List

> Postings remain property of MB Coupes, L.L.C.