[W126 Coupe] 560 SEC Hydraulic Suspension Pump Rebuild

[Mike R.]

Nope. There's a paper gasket on the back and that's about it back there. I
think I used a socket to push the new shaft seal in place, with a vise. Just
make sure you do all three big o-rings in the pump like I showed you. You
have to do all three or it will leak (again/still).
 
Mike
 
From: mbcoupes-bounces at mbcoupes.com [mailto:mbcoupes-bounces at mbcoupes.com]
On Behalf Of Henry Viveiros
Sent: Tuesday, March 09, 2010 4:11 PM
To: Mbcoupes at Mbcoupes. Com
Subject: [W126 Coupe] 560 SEC Hydraulic Suspension Pump Rebuild
 
I have removed the pump and will get some Brake Clean tomorrow to clean it
up. I have the gasket, shaft seal, and the O-ring between the pump front &
rear. I'll look inside to find anything else that I might replace when I get
the pump cleaned up.
Do I need to do anything about the shaft coming out of the engine? Is there
anything I should know about replacing the shaft seal-just pick it out and
place it back or press it in and out? Anything else?
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.436 / Virus Database: 271.1.1/2730 - Release Date: 03/09/10
07:33:00
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.pairlist.net/pipermail/mbcoupes/attachments/20100309/c695c19f/attachment.htm>