[W126 Coupe] Inside Door Opener Handle

[Jay Hirsch]

I have photos  of this, went through the same thing a few months ago  
and  did not want to forget anything.
Right now the photo part of my computer is in a rebuild mode, will  
send the image in an hour
Jay H
On Apr 26, 2010, at 5:07 PM, Dick Spellman wrote:


> On 4/26/2010 4:58 PM, Henry Viveiros wrote:

>>

>> The metal latch that opens the door.

>>

> Henry,

>

> You should be able to get at the foot of the latch which is secured  

> with phillips and press forward enough to remove the droop and then  

> tighten this up without removing the door panel.  You may need to  

> separate the seat controls plastic (pull the switch covers, remove  

> the retainer clip) to gain the needed room to access the phillips  

> bolt.  Start with what I suggested in the first email and go from  

> there.  Be careful working around the wood trim.  Good luck.

>

> Dick

> The MB Coupes Website!

> W126 SEC Mailing List

> Postings remain property of MB Coupes, L.L.C.