[W126 Coupe] Seat Belt Presenter Problem

[Dick Spellman]

Hi Tom,

That seatbelt triangle shaped tip at the end of the arm extension is a 
replaceable part.  Try either a wrecker yard or the local MB dealer or 
perhaps Jonathan. The center on one of the legs of the triangle /should/ 
have a snap in piece that permits sliding the tip through the belt 
webbing.  I'd be guessing that the floor bolt is also visible on the lap 
belt and can be removed with the tri then slid over, not sure as I have 
not been in my coupe in some time.  This presumes nothing is lodge in 
the opening that you can't break free without removing the rear side panel.

As for slow operation.  It's is probably a really good idea to lube up 
the teeth on the extension and pray the original nylon gear to metal 
gear is not too badly worn from the stress of pushing pulling the arm on 
aged grease.  I use that MB slide paste stuff on all these kinds of 
things.  Don't know if there is anything else that would last as long.

Regards,
Dick

toelsner at comcast.net wrote:

> Group,

> The guide the seat belt goes through on the driver's side broke off 

> from the presenter arm. The motor itself is fine and the arm extends 

> and retracts with no problem. Does anybody have the documented 

> procedure for replacing the arm? Do I need to remove the inside rear 

> panel to gain access? If so, does anybody have instructions?

>  

> Also, is it common for the seat belts themselves to retract/coil at a 

> snails pace? Or leave part of it not completely retracted? Is there a 

> fix for this? Thanks again to all.

>  

> Tom Oelsner

> ------------------------------------------------------------------------

>

> The MB Coupes Website!

> W126 SEC Mailing List

> Postings remain property of MB Coupes, L.L.C.


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.pairlist.net/pipermail/mbcoupes/attachments/20080129/ce919dd9/attachment.html>