[W126 Coupe] Electrical / start problem

[Shin Takei]

 Bellamy,
Interesting you mention the W124 because the exact same thing iis happening to my wife's '94 E320. See below: 


 












"....He suggests you check the ignition switch connector where the harness meets the back of the ignition key assembly.? He's seen the behavior you describe on other MB's and says it's a $20 MB dealer part but, he charges $200 with labor to do the repair....."

?

Haha.? Why?? Because?if the problem is the ignition switch (the other end of the ignition/steering lock assembly to which the wiring harness plugs) the easiest way to get at it on the W126 is to remove the engine and use a torch to?cut holes in the firewalls beside the steering column.? And THAT operation is a piece of cake compared to what is necessary?the W124!!

?

Seriously, I question whether that is the problem.? When you turn the ignition "on" all the dash warning lights light (including the low fuel), right?? That's normal.? That's your "test" to see that all your warning lights work.? When you further engage the starter the warning lights will go out when the engine starts.? That's normal. THIS IS WHAT IS HAPPENING.

?

Question: Do your wipers come "on" when you turn the key to ignition position, and do they also keep running independently of the wiper switch when the engine is running?? YES What happens when you actually turn the wipers "on"?? (I have lost your original message, I suspect the wipers?still run). YES. What happens when you switch the wipers to intermittent?? What happens when you switch to fast speed??? ALL POSITION WORKS UNTIL I SWITCH IT OFF. BY THIS TIME THE ENGINE IS OPERATING NORMALLY.

?

Power is provided to the wiper switch (& relay)?through the ignition switch and the wipers?will only work when the ignition is "on".? The problem is likely with the wiper?switch itself, not the ignition switch.? Sounds like your ignition switch performs perfectly normally and your wiper switch is locked (broken) "on". IS THAT DRAWING THE POWER AWAY SO THE STARTING IS WEAK?

?

By coincidence actually, we were just talking about how to remove the turn signal/wiper assembly.??Except in your case?you have airbags.? Unfortunately, the easiest way to remove the wiper?stalk assembly in?YOUR car is to remove the engine and cut the steering shaft off at the steering box?....? I'M JUST KIDDING!!!? but DO ask someone about dealing with the airbag equipped steering wheel... I have had no experience.? And DON'T try?anything?about removing that steering wheel?without fully understanding the procedure! I HAVE REPLACED MY W126 STEERING WHEEL WITH A WOODEN ONE. JUST DISENGAGE THE AIRBAG CONNECTOR UNDER THE PASSENGER FOOTWELL CARPET/RUBBER MAT, UNSCREW THE 2 HEX BOLTS BEHIND THE STEERING WHEEL AND CAREFULLY LIFT AWAY THE AIR BAG COVER. THEN THE NORMAL STEERING WHEEL BOLT APPEARS.? I DISCONNECTED THE BATTERY FOR ADDITIONAL SAFETY.

THANKS FOR YOUR INPUT.

?

SHIN

?

?











?



 =


 





The MB Coupes Website!
W126 SEC Mailing List
Postings remain property of MB Coupes, L.L.C.



 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.pairlist.net/pipermail/mbcoupes/attachments/20080824/7b777813/attachment.html>