[W126 Coupe] (no subject)

[Camran Nassiri]

Jay- I don't know about your engine problem; but, the head reast comes out very easily.  Just raise the head rest all the way up as far as it goes by holding the head rest botton.  Then reach behind the seat and you'll see a bump on the back of the seat.  Push in that bump and pull the head rest the rest of the way by hane.
 
Camran
91 420SEL, 90 560SEC


From: JohnJayKimrey1 at aol.comDate: Fri, 1 Jun 2007 10:05:05 -0400To: mbcoupes at mbcoupes.comSubject: [W126 Coupe] (no subject)

I own a 1989 560SEC (80k miles) and have a problem with an oil leak. Specifically, a valve cover(passenger side) gasket to head leaks oil at lower rear just above where the exhaust begins to turn down toward rear of car. A new gasket was installed but did not fix the problem. The cover appears not to be warped and no light shows through on flat surface.Is there a sealant that will seal aluminum to rubber or is there something that I may be missing. 
Also can the auto head rests  be removed to install sheepskins with pre formed holes without taking apart upper part of front seat? Any help is appreciated.  
Thanks,
Jay K.


See what's free at AOL.com. 
_________________________________________________________________
Live Earth is coming.  Learn more about the hottest summer event - only on MSN.
http://liveearth.msn.com?source=msntaglineliveearthwlm
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.pairlist.net/pipermail/mbcoupes/attachments/20070601/5bf56db3/attachment.html>